You must have javascript enabled to use rc-car.org !

Rofun 5T 1/5 Scale RC 32cc Gasoline Ready to Run Baja Truck Red 320T Rovan

USD $879.00

Condition : New

Free Shipping

{{variant_type_name}} :
eBay
SKU: 5T-RED-00-32 This site contains affiliate links for which we may be compensated Toys & Hobbies / Radio Control & Control Line / RC Model Vehicles & Kits / Cars, Trucks & Motorcycles

Notify me when the price drops

We will email you if we find a lower price on this product!

Target price (USD) $


    • View our extensive line of Rovan Vehicles on eBay Here 
  • Wheel Base: 22 3/8 Inch

    Approximate Overall Size: 38 1/8" Long x 17 3/8" Wide x 10" High

    Weight: 35 1/4

    Tires: 5SC third-generation All Terrain tires, 15.75inch Rear 15.5 Front

    Clutch: 8000 RPM wear-resistant clutch, Metal clutch tripod

    Improved Steering:60KG metal gear steering servo, Symmetric steering, New proportioning kettle

    Suspension & Drive: Second generation reinforced front and rear suspension, 6mm shock absorber

    Cage: Front and rear anti roll bars

    Radio:2.4G Six Channel Remote Control RC-X6

    Vehicle Battery:SC6V2000 mAh battery

    Drive Train: Metal differential housing, 9mm half shaft, Rear wheel drive, Rear axle braking

    Servos:18KG metal gear throttle servo, 60KG metal gear steering servo

    Clutch: 8000 RPM wear-resistant clutch Clutch

    Assembly and Operation:

    Out of the Box: Ready to race once the wheels are installed and the car battery has been charged. Minimum 2 hours charge recommended.

    Battery Charging: The Truck features a charging plug and comes with a USB charger. No disassembly required for charging. Allow battery to cool down for 30 minutes after full charge before operation. Remove charger within 30 minutes of full charge (green light) to prolong battery life. Store battery fully charged.

    Crash Durability: Minor crashes are unlikely to cause significant if any damage. Very Tough & Forgiving


    Specifications For 5T Series Trucks.

    1. 32cc two-stroke four point fixed gasoline engine

    2. Body length x width x height LxWxH: 38 3/16"x17 5/16"x13 3/8"

    3. 393/16" in front of the wheelbase and 15 3/4" in back

    4. Wheelbase 22 7/16"

    5. Rear wheel drive

    6. Rear axle braking

    7. 18KG metal gear throttle servo

    8. 60KG metal gear steering servo

    9. Dominator exhaust pipe

    10. Metal differential housing

    11. 5T/5SC third-generation highway tires

    12. 1/4" plastic shock absorber

    13. SC6V2000 mAh battery

    14. Non LCD 2.4G Six Channel Remote Control RC-X6

    15. 8000 RPM wear-resistant clutch

    16. Second generation reinforced front and rear suspension

    17. Front and rear anti roll bars

    18. 3/8" half shaft (dog bone)

    19. Metal clutch tripod

    20. Symmetric steering

    21. New closed nuts

    22. New proportioning kettle

    23. Net weight: 13.5kg

    24. Gross weight: 18.5kg

    25. Outer packaging size LxWxH: 990x19 11/16"x14 9/16"

  • Fuel Mixing: Uses a 25:1 gasoline-to-oil ratio. Fill the small compartment of the mixing jug to the 25:1 line with oil, then fill the gas compartment to the 25:1 line. We’ve had great results with Evinrude Johnson Outboard Premium 2-Stroke Engine Oil, which minimizes carbon buildup and avoids plug fouling.

    Radio Instructions:

    This 6-channel radio essentially only uses 2 channels with this car. Trim is on the 4 adjustments under the cover on the back of the radio. Top left - steering trim. Top right - throttle & brake trim, Bottom left - control extents.

  • Starting Instructions:

    1. Ensure the car and radio are powered on and responding.
    2. Set the choke on the right side of the car (red lever on the carburetor) to the vertical closed position.
    3. Press the primer bulb on top of the carburetor 3 to 4 times, or once fuel is visible.
    4. Gently pull the starter rope until it engages, then pull swiftly. Do not pull the rope out completely; use short quick pulls.
    5. Crank until the engine fires (usually 1 to 3 pulls).
    6. Turn off the choke, then pull the rope 1 or 2 times to start the engine.

    Break-In Process:

    1. Initial Run: Start by running the car at idle to 1/4 throttle or less for about 5 minutes. Let the engine cool down completely after this run.
    2. Second Run: Repeat the same process less for 10 minutes, then allow it to cool down.
    3. Third Run: You can start pushing it a little harder, but keep in mind that a new engine generates more heat due to increased friction. Run for 8 to 10 minutes, then let it cool.
    4. Subsequent Runs: Continue the process for about five runs, being mindful of any debris that could block cooling. A clean engine runs cooler.
    5. Final Break-In: After these runs, you can run the car at full throttle and let it burn through an entire tank of fuel.
    6. Post-Break-In: Be sure to check and snug up the exhaust pipe after the initial break-in process.
    7. Before each run check bolts throughout the car to ensure they are tight. Lock-tight is recommended on clutch and brake assembly bolts. clean bolts and holes with alcohol and a q-tip to ensure lock-tight adhesion.

  • You will be tempted to upgrade some of the parts to aluminum. But let me tell you, aluminum is unforgiving, breaks and destroys everything behind it. The High Strength ABS Plastic will give and bounce back without damage. Many plastic components are way better.  
  • Failsafe & Servo Protection Notice: 

    Rofun RC vehicles are equipped with an automatic braking failsafe system. This system activates whenever the receiver is powered on but not receiving a signal from the transmitter. Do not leave the vehicle powered on with the transmitter turned off. In this condition, the throttle/brake servo remains engaged continuously. Prolonged engagement can cause overheating and will damage internal components, including the servo capacitor and circuit board. Always power on the transmitter before the vehicle, and turn off the vehicle before shutting down the transmitter.

  • Disclaimer and Safety Notice:

    All items offered by 5TRC are brand new. 99.9% of our customers experience no issues with the products. However, if you are new to the hobby, we strongly encourage you to watch our instructional videos, available through YouTube. Rofun and Rovan products sold by 5TRC through eBay, are sold without warranty, express or implied. Due to the nature of the hobby, these vehicles are typically customized and modified by enthusiasts. Accordingly, all products are sold without guarantees of any kind. However your purchase may be covered by ebay money back gurantee. Please be aware that these items can cause severe burns from the exhaust if handled improperly. Improper use can also result in serious injury or death caused by impact to the operator, bystanders, or pets in the area of operation. By purchasing this product, you agree to hold harmless 5TRC from any and all liability for accidents, injuries, or damages that may result from the use or misuse of this product.

Rofun 5T 1/5 Scale RC 32cc Gasoline Ready to Run Baja Truck Red 320T Rovan
rovan
See more
Price type
IN STOCK OUT STOCK